1nz Ecu Pinout [ 480p 2025 ]

If you have no spark and no injector pulse, check pin E5-5 (Black/Red). If this is dead with the key on, the EFI main relay is not engaging or the ECU is not pulling the relay coil to ground. Sensor Inputs (How the ECU Sees the World) The 1NZ-FE uses a Speed-Density system (MAP sensor) rather than a MAF, except for some California-spec models.

| Component | Connector | Pin | Control Type | Wire Color | | :--- | :--- | :--- | :--- | :--- | | | E5 (A) | 10 | Switched Ground (12V feed) | Blue | | Injector 2 | E5 (A) | 9 | Switched Ground | Yellow | | Injector 3 | E5 (A) | 8 | Switched Ground | Green | | Injector 4 | E5 (A) | 7 | Switched Ground | Red | | Igniter (IGT) | E5 (A) | 11 | 5V Trigger (Ignition timing) | White | | Fuel Pump Relay | E7 (C) | 4 | Switched Ground (Priming) | Green/Red | | VVT Solenoid | E5 (A) | 12 | Switched Ground | Blue/Yellow | 1nz ecu pinout

| Sensor | Connector | Pin | Signal Wire | Voltage/Spec | | :--- | :--- | :--- | :--- | :--- | | | E6 (B) | 23 | Light Green | 3.0-3.8V @ idle; ~1.0V @ decel | | TPS (VTA) | E6 (B) | 22 | Blue/Red | 0.5V (Closed) to 4.5V (WOT) | | Engine Coolant Temp | E6 (B) | 20 | Red/White | 2.5V cold to 0.2V hot | | Cam Position (VVT-i) | E6 (B) | 9 | Yellow | 5V square wave | | Crank Position (NE) | E6 (B) | 8 | White | 5V square wave | If you have no spark and no injector