Kenwood Tkm-707 Mods -

The Mod (The Swap): This radio uses the same 8.83 MHz IF filter as the TS-440S. The stock filter (YF-107C) is adequate. The upgrade is to source a (or a comparable 2.7 kHz or 2.8 kHz filter). The Result: Open, broadcast-like receive audio. The difference is startling—suddenly, the radio sounds like a high-end desktop unit. Combined with the radio's excellent noise blanker, weak signal copy improves dramatically. 3. The Usability Mod: Adding a "Clarifier" (Fine Tuning) The Problem: The TKM-707 has a "RIT" (Receiver Incremental Tuning) button, but it’s clunky. You press and turn the main knob. It resets when you change channels. For chasing drifting DX stations, this is frustrating.

This piece dives into the most interesting (and often undocumented) modifications that transform this marine workhorse into a ham radio's dream. 1. The Big One: Unlocking General Coverage Transmit (The "Mars Mod") The Problem: Out of the box, the TKM-707 is channelized and locked to ITU maritime frequencies (typically 1.6–27.5 MHz TX). You cannot dial up 7.200 MHz USB for the nightly ham net. Kenwood Tkm-707 Mods

The Mod: This is a simple diode removal. Inside the radio, near the front panel board, is a series of jumper diodes (often labeled D12, D13, D14, etc.). By removing a specific diode (usually D13 or D14, though you must consult the service manual for your board revision), you disable the frequency mask. The Result: Your marine radio suddenly becomes a 150-watt (PEP) ham transceiver on 160m through 10m. Note: This is illegal to use on ham bands without a license, and illegal on other frequencies regardless. Use responsibly. 2. The Performance Mod: Widening the SSB Filter The Problem: The TKM-707’s stock 2.4 kHz SSB filter is fine for marine voice, but for amateur rag-chewing, it feels a bit narrow and "pinched," lacking low-end audio warmth. The Mod (The Swap): This radio uses the same 8