Let’s face it: half the fun of amateur radio is the tinkering. We love solving the little problems—the RF in the shack, the cable mess behind the desk, the soldering iron that’s never hot when you need it. Here’s a fresh batch of hints and kinks to save you time, money, and frustration. The problem: You slip a ferrite bead over a coax cable, but it rattles around and slides right off the bend. Not effective.
Zero adhesive residue. Removes cleanly. UV and weatherproof for years. Temperature range: -60°F to +500°F. One roll seals dozens of connectors. Use it over electrical tape, not under. 5. The Ruler-on-the-Mast Trick (Antenna Matching) The problem: You’re tuning a 1/4-wave ground plane or a J-pole. You slide the radiator up and down, mark it with a Sharpie, lower the mast, adjust, raise again… repeat.
Strip the insulation off a length of stranded hookup wire (16–22 AWG). Unravel the braided shield or simply flatten the stranded core. Dip the bare copper in rosin flux (paste or liquid). Apply your soldering iron to the joint and touch this makeshift wick to the molten solder. New- Hints and Kinks for the Radio Amateur
Now get on the air—and keep the hints coming.
Buy a silicone baking mat (meant for cookies, about $10–15). They are heat resistant to 450°F, non-slip, and have a slight lip. The best part: the non-stick surface means solder balls don’t adhere—they just roll into a corner for easy vacuuming. Let’s face it: half the fun of amateur
Before snapping the bead onto the cable, wrap the coax with one layer of friction tape (cloth electrical tape) or two wraps of vinyl electrical tape where the bead will sit. Then push the bead over the taped section.
73, and may your SWR be low and your soldering iron hot. Do you have a kink to share? Send it to your club newsletter or post it on QRZ—that’s how our tradition stays alive. The problem: You slip a ferrite bead over
Use vulcanizing silicone tape (often sold as "rescue tape" or "self-fusing silicone tape"). It’s about $8–10 per roll. Stretch it 100% as you wrap—it fuses to itself into a solid rubber sleeve.