|
Ñåðâèñ R-P-M
Êëóáíûé ïàðòíåð
|
| Ñêèäêà îò êëóáíîãî ïàðòíåðà ïðè ðåãèñòðàöèè â êëóáå |
| Âíèìàíèå! Ïðè ðåãèñòðàöèè â íàøåì êëóáå, äëÿ ÷ëåíîâ, â ðàìêàõ ïàðòíåðñòâà ïðåäîñòàâëÿåòñÿ ñêèäêà 15% íà ðàáîòû â ñåðâèñå R-P-M. |
|
|||||||
| Â |
|
Â
|
Îïöèè òåìû |
Disclaimer: These are community-sourced; always verify with continuity. 4.1 Serial Console Output (example boot log) Format: Log Type - Time(microsec) - Message S - QC Image Loader S - Boot XA S - JTAG disabled by OEM S - Serial enabled S - Entering EDL mode via forced USB 4.2 EDL Access With R6400 shorted to GND during USB connection, the device enumerates as:
| Interface | Signal | Typical Pad Location (near eMMC/SoC) | Voltage | |-----------|--------|--------------------------------------|---------| | | TX | Resistor pad (R600 series) | 1.8V | | UART | RX | Adjacent to TX | 1.8V | | EDL | Force USB | Pulled low resistor (R6400) | 0V to 1.8V |
Disclaimer: These are community-sourced; always verify with continuity. 4.1 Serial Console Output (example boot log) Format: Log Type - Time(microsec) - Message S - QC Image Loader S - Boot XA S - JTAG disabled by OEM S - Serial enabled S - Entering EDL mode via forced USB 4.2 EDL Access With R6400 shorted to GND during USB connection, the device enumerates as:
| Interface | Signal | Typical Pad Location (near eMMC/SoC) | Voltage | |-----------|--------|--------------------------------------|---------| | | TX | Resistor pad (R600 series) | 1.8V | | UART | RX | Adjacent to TX | 1.8V | | EDL | Force USB | Pulled low resistor (R6400) | 0V to 1.8V |
